Lexmark T642 Service Manual - Page 92
Fuser, assembly removal on, Fuser exit sensor, service check on,
UPC - 734646722001
View all Lexmark T642 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 92 highlights
4061-xx0 User attendance messages-paper jams and paper handling errors (2xx.xx) Error code Sub codes Description Possible causes Action 201 .92 201 .94 Page did not reach exit sensor. Fuser page count is not available. Expected wide page not detected by narrow media sensor, possible accordion jam. Fuser page count is not available. • Page jammed on fuser input guide. • Page did not enter or exit fuser nip cleanly. • Exit sensor not functioning correctly. • Page did not enter or exit fuser nip cleanly. • Narrow media sensor not functioning correctly. • Actual page is narrow when wide page was expected. • Check the fuser entry guide for toner build up. • Check the fuser for wear or contamination. If a problem is found, replace the fuser assembly. See "Fuser assembly removal" on page 4-26. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-92. • If label media, ensure front edge meets 1/8 inch requirement. • Check the fuser for wear or contamination. If a problem is found, replace the fuser assembly. See "Fuser assembly removal" on page 4-26. • If media is narrow, then turn off first sheet detection (engine settings 3 = 16). In Diagnostics mode, select PRINTER SETUP and Engine Setting 3. • The fuser narrow media sensor may not be functioning properly. Go to "Fuser narrow media sensor service check" on page 2-93. 2-52 Service Manual