Lexmark T642 Service Manual - Page 98

4061-xx0 User attendance messages-paper jams and paper handling errors (2xx.xx) Error code Sub codes Description Possible causes Action 202 .22 202 .23 202 .24 202 .26 Exit sensor covered too long. Fuser page count between 200,000 and 299,999. Page may be jammed in fuser exit or redrive area. • Make sure the redrive door is complete closed. • Check the fuser for any signs of wear or contamination. If any are found, replace the fuser assembly. See "Fuser assembly removal" on page 4-26. • Turn media over to reduce +W curl. • Check upper redrive diverter and diverter spring for any signs of damage, a loose spring, or binding parts. Repair the redrive as necessary. • Check any installed output options(s) that may be installed for correct installation and alignment. • The fuser exit sensor may not be functioning properly. Go to "Fuser exit sensor service check" on page 2-92. Page is covering narrow media sensor during warm up. Fuser page count between 200,000 and 299,999. • If page is not visible from front or rear of the printer, a partial piece of page may be torn off in the fuser covering the narrow media sensor. • The narrow media sensor or flag may be dislodged or damaged. Check the fuser and area around the fuser assembly for any signs of debris or pieces of paper or media. Exit sensor may have bounced. Fuser page count between 200,000 and 299,999. Exit sensor assembly Go to "Fuser exit sensor service check" on page 2-92. Page is covering the exit sensor during warm up. Fuser page count between 200,000 and 299,999. Something is keeping the exit sensor covered. A page may not have been cleared from a prior jam. Check the fuser and area around the fuser assembly for any signs of debris or pieces of paper or media. 2-58 Service Manual