Lexmark T642 Service Manual - Page 79
Reset Active Bin, PPDS Font Error
UPC - 734646722001
View all Lexmark T642 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
4061-xx0 User attendance messages (continued) Error code Sub code Primary message 37 .xx Insufficient Memory 38 .xx Memory Full 39 .xx Complex Page 50 .xx PPDS Font Error 51 .xx Defective Flash Description/action This message displays when the printer memory used to restore the Print and Hold jobs from the disk and found that some or all of the jobs could not be restored. The printer ran out of memory while attempting to restore the jobs. • Press to clear the message. Some of the Print and Hold jobs on the disk will not be restored. They remain on the disk, but cannot be accessed. • Press until Busy/Waiting appears. The following functions may be available: - Cancel Job - Reset Printer - Reset Active Bin This message displays when the printer is processing an incoming job and there is insufficient memory available to continue processing the job. The following actions may be taken: • Press to clear the message. Perform the defragment operation: - Perform the defragment operation - Delete fonts, macros, and other data in RAM - Install additional memory • Press to display Busy/Waiting. The following functions may be available: - Cancel Job - Reset Printer - Reset Active Bin This message displays when the page is too complex to print. The following actions may be taken: • Press to clear the message and continue the job. Some data loss may occur. Simplify the print job and reprint, if necessary. • Press until Busy/Waiting appears. The following selections are possible: - Cancel Job - Reset Printer - Reset Active Bin This message displays when the PPDS interpreter has encountered a font error. Note: This error may only occur when the printer is formatting PPDS print data. The following actions may be taken: • Press to clear the message and continue processing the job. • Press until Busy/Waiting appears. The following are available: - Cancel Job - Reset Printer - Reset Active Bin This message displays when the printer detects a defective flash. This error may occur at power on, or during flash format and write operations. Press to clear the message. The flash is marked as bad and normal operation continues. Flash operations are not allowed until the problem is resolved. Diagnostic information 2-39