Lexmark T642 Service Manual - Page 74

4061-xx0 User attendance messages (continued) Error code Sub code Primary message Description/action Disk Corrupted Reformat? The printer has detected there are errors on the hard disk that cannot be corrected. The disk cannot be used until it is reformatted. Warning: All data on the disk will be lost if you format the disk. The following actions can be taken: • Power off and remove the disk. The disk will not be formatted. • Press to format the disk. All data is lost when you format the disk. Empty Box M This message is displayed when the hole punch alarm is on and the printer informed by the code the hole punch box M is full. The following actions may be taken: • Empty the hole punch box. • Press to ignore the message. The Box M Full appears on line 2 of the display and the job is printed without hole punching. The message remains until the box is emptied. If this message continues to be displayed when the box has been emptied, go to "StapleSmart finisher service check" on page 2-123. Insert Box M This message is displayed when the hole punch box is missing or installed incorrectly. The message is displayed during any of the following times, regardless of the hole punch alarm setting: • At POST • After the finisher side door has been closed • Before the first page of a job requesting hole punch. The message displays once per job. The following actions can be taken: • Install the hole punch box. • Press to ignore the message. The Box M Missing message appears on the status line. A job that is set for hole punching will not be punched. The message continues to display on all subsequent jobs that request hole punching. If this message cannot be cleared after inserting the box, go to "StapleSmart finisher service check" on page 2-123. Insert Cartridge or Close Door This message displays when the printer front door is open or the print cartridge is missing. If this message cannot be cleared, go to "Cover closed switch/cable service check" on page 2-80. Insert Staple Cartridge This message displays when the staple cartridge is missing or installed incorrectly. The message appears, regardless of the Staple Alarm setting, at the following times: • At POR • After the Stapler Door has been closed. The following actions can be taken: • Install the stapler cartridge. • Press to clear the message. The printer handles stapled jobs as if the staple cartridge were installed, but empty. The Staples Empty message appears on the status line and the Load Staples may display. 2-34 Service Manual