Linksys SGE2000 Cisco Small Business SFE/SGE2xxx Series Managed Switches Admin - Page 205
Supported IP Format, Link Local Interface, Configuring IP Information, Add Static Default Gateway
UPC - 745883572120
View all Linksys SGE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 205 highlights
Configuring IP Information IP Addressing 7 - Reachable - Indicates that a positive confirmation was received within the last Reachable Time. - Stale - Indicates that the previously known neighbor is no longer reachable. No action is taken to verify its reachability, until traffic needs to be sent. - Delay - Indicates previously known neighbor is no longer reachable. Device is in Delay state for a predefined Delay Time that if no reachabiltiy confirmation is received, the state changes to Probe. - Probe - Indicates the neighbor is no longer reachable, and unicast Neighbor Solicitation probes are being sent to verify reachability. STEP 2 Click the Add button. The Add Static Default Gateway Page opens: The Add Static Default Gateway Page provides information for adding a static Default Gateway. Add Static Default Gateway Page The Add Static Default Gateway Page contains the following fields: • Supported IP Format - Indicates the supported IP version is IPv6. • IPv6 Address Type - Indicates the IPv6 address is link local IP address, that uniquely identifies hosts on a single network link. A Link-local address has a prefix of 'FE80'. The link-local addresses are not routable and can be used for communication on the same network only. • Link Local Interface - Indicates the Link Local Interface. The possible field values are: - VLAN - Indicates the VLAN is the Link local interface. Cisco Small Business SFE/SGE Managed Switches Administration Guide 196