Panasonic HPX300 Operating Instructions - Page 151
Warning System, Warning Description Tables
UPC - 791871304297
View all Panasonic HPX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
Chapter 9 Maintenance and Inspections Warning System Warning Description Tables If a problem is detected immediately after the power is turned on, or during operation, this will be indicated by the WARNING lamp, lamps inside the viewfinder and a warning tone. Priority Warning type LCD or viewfinder indication Tally lamp Warning lamp Alarm tone*6 Warning description and recording/playback Countermeasures operation SYSTEM ERROR 1 System error Cause indication *1 Red blinking Blinks 4 times per second Blinks 4 times per second Continuous P2 microprocessor or control tone failure. Operation stops. Check the cause indication *1 and consult your distributor. Incorrect 2 P2 card removal TURN POWER OFF Blinks red Blinks 4 times per second Blinks 4 times per second A P2 card was removed Continuous tone during access and card data was corrupted. Both access LEDs light orange. Turn off the power. Repair the P2 card if the clips on the card are corrupted. LOW BATTERY Red blinking, and the battery The battery is exhausted. The level bar blinks with 3 battery is the empty status. (This exhauseted indication appears also Blinks 1 time per second Lights Continuous tone Recording and playback stop. The camera stops automatically when the Replace the battery. when MENU indications voltage drops. have been turned OFF.) Blinks 4 P2 card fully P2 FULL times per Lights after Continuous tone after No more space on P2 Delete clips that are 4 recorded Blinks red (appears only for second after completing 3 seconds in MCR mode.) completion recording completing cards left for recording.Stop recording.*3 recording of recording. no longer needed or insert a new card. Turn the power off and then back on 5 Recording error REC WARNING Cause indication *2 Blinks red Blinks 4 times per second Blinks 4 times per second Intermittent A recording error has tone 4 occurred. The error may times per terminate recording or let it second continue. *4 again and check recording and playback. Replace any P2 card that does not enable normal recording. An irregular reference signal input to GENLOCK IN prevents normal recording Irregular 6 reference signal TEMPORARY PAUSE IRREGULAR FRM SIG Blinks red. Blinks 4 times per second Blinks 4 times per second Intermittent by pausing recording. The tone 4 recorded clip is divided. Check the times per • Recording resumes when GENLOCK IN signal. second the signal returns to normal. Recording does not resume if interval, one-shot or loop recording is in progress. Drop in reception 7 quality of wireless WIRELESS RF Blinks red receiver transmission Blinks 4 times per second (Recording only) Blinks 4 times per second No Indicates poor reception from the wireless receiver. Recording continues but wireless microphone cannot be received. Check microphone power supply and receiver reception status. (Continued on the next page) 151