Panasonic HPX300 Operating Instructions - Page 91
White Shading Compensation, White Shading Adjustment
UPC - 791871304297
View all Panasonic HPX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Chapter 5 Preparation White Shading Compensation The camera can use DEFAULT (fixed value) and three user adjustable functions (USER1, USER2, USER3) to store white shading compensation data. Select SHADING SELECT in the setting menu LENS SETUP screen to set compensation data. Selecting OFF turns off shading compensation. Selecting White Shading Compensation Data 1 Select SHADING SELECT in LENS SETUP, then press the JOG dial button. For details on menu operation, refer to [Using the menus] (page 120). LENS SETUP SHADING SELECT SHADING(USER) CAC CAC PROPERTY CAC CARD READ CAC FILE DELETE CAC FILE INIT IRIS ADJUST DEFAULT >>> ON >>> PUSH MENU TO RETURN 2 Use the JOG dial button to select DEFAULT, USER1, USER2, USER3 or OFF and press the JOG dial button. • To adjust the white shading, select USER1, USER2 or USER3. • The USER1, USER2 or USER3 settings do not contain any compensation data by default. • DEFAULT stores compensation data that suits XT17x4.5BRM-K14. For lenses other than those above, perform the "White Shading Adjustment" described below. LENS SETUP SHADING SELECT SHADING(USER) CAC CAC PROPERTY CAC CARD READ CAC FILE DELETE CAC FILE INIT IRIS ADJUST DEFAULT USER1 USER2 USER3 OFF >>> >>> >>> PUSH MENU TO RETURN White Shading Adjustment NOTE Coloring may occur in the vertical direction near the open setting of the lens iris even when the white shading has been adjusted. This is an optical characteristic and not indicative of a failure. 1 Place the camera in the adjustment mode. (1) M ount a lens on the camera. • Do not forget to connect the lens cable. (2) T urn the shutter switch off and set 0 dB gain. (3) If the lens comes with an extender, disengage it. (4) O pen the setting menu LENS SETUP screen and select USER1, USER2 or USER3 under SHADING SELECT. (5) U se the JOG dial button to select SHADING (USER), select EXECUTE and press the JOG dial button. • The message "CHECK LUMINANCE LEVEL ZEBRA ON VF" appears. LENS SETUP SHADING SELECT SHADING(USER) CAC CAC PROPERTY CAC CARD READ CAC FILE DELETE CAC FILE INIT IRIS ADJUST USER1 RETURN EXECUTE >>> PUSH MENU TO RETURN CHECK LUMINANCE LEVEL ZEBRA ON VF SHADING: USER1 SET OK? YES NO PUSH SET 91