Panasonic HPX300 Operating Instructions - Page 154
Panasonic HPX300 - Camcorder - 1080p Manual
UPC - 791871304297
View all Panasonic HPX300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 154 highlights
(Continued from the previous page) Item HDD (USB HOST MODE) Message Description CANNOT ACCESS CARD! An error occurred during P2 card access. CANNOT ACCESS TARGET! An error occurred during hard disk access. CANNOT FORMAT! The hard disk cannot be initialized. CANNOT RECOGNIZE The destination target cannot be properly HDD! recognized. CARD IS EMPTY! CANNOT COPY! The P2 selected for copying is empty. HDD CAPACITY FULL! Not enough space left on the hard disk. HDD DISCONNECTED! The unit is not connected to a hard disk. MISMATCH COMPONENT! P2 CARD IS UNFORMATTED! PLEASE FORMAT P2 CARD! TOO MANY PARTITIONS! Copying cannot be made because the destination card is in the wrong format. The P2 card is not formatted. This warning indicates that data could not be imported from a hard disk to a P2 card because the P2 card contained recorded data. There are too many partitions. TOO MANY TARGETS! Multiple devices are connected. UNKNOWN DEVICE CONNECTED! The connected DVD drive is not compatible. VERIFICATION FAILED! The compare check after copying failed. Measure Check P2 card. Check hard disk status and connection. Connect another hard disk drive. Reboot the hard disk or connect a different hard disk. Copying is not performed since the card is empty. There is not enough space on the connected hard disk. Use a new hard disk or formatted hard disk. Reconnect the USB cable. If the hard disk does not operate normally, turn it off and turn it back on again. Use a P2 card with the same model number or import video in clip units. Use a formatted P2 card. You cannot copy to a P2 card that contains data. Format the card on a P2 device and copy again. Hard disks can handle up to 23 partitions. Use a new hard disk or formatted hard disk. Disconnect devices, turn off the unit and turn it back on again. Disconnect devices, turn off the unit and turn it back on again. Copy the data again. Chapter 9 Maintenance and Inspections 154