Panasonic WVCU650 Operating Instructions - Page 19
SETUP PROCEDURES (FIRMWARE), Administrator Password Entry, Setting Modes
UPC - 791871504277
View all Panasonic WVCU650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
SETUP PROCEDURES (FIRMWARE) ■ Administrator Password Entry If you log into the system in the administrator mode, PS·Data communication setting, all reset, operator password check. and database copy will become available. To activate the administrator mode, you need to enter the administrator password. Notes: • The factory default of administrator password is "650". However, for security, you should change the password setting. To change the setting, refer to p. 24. • Take a note of your administrator password. ■ Setting Modes If you power on the system controller while pressing the following buttons, the system will run in an associated setting mode. Notes: • You cannot change the system from the following modes (refer to the diagram) to the normal operation mode. To start up the normal operation mode, turn off the system controller, and then turn on the controller again. • The administrator password entry is required for the following modes. Buttons pressed while the power-on 2, 4, and 6 Setting Mode All reset MON (ESC) and 6 MON (ESC) and 1 PS·Data Communication setting Administrator password change Description The communication settings and PS·Data database can be restored to the factory default.* PS·Data communication setting can be performed. The administrator password can be changed. MON (ESC) and 2 PS·Data database copy The PS·Data database can be copied from the source system controller (Controller No. 1) to a destination system controller. MON (ESC) and 4 PS·Data password display The passwords of up to 16 operators can be displayed on the LCD. * The panning, tilting, and zooming calibration settings are not restored. 19