Panasonic WVCU650 Operating Instructions - Page 42

■ Camera Position Control Camera position is the association of camera numbers and preset position numbers. Up to 1 000 camera positions are registrable in the system, and you can move a desired camera to a desired preset position only by entering a camera position. Note: To activate this function, preset positions and camera positions need to be registered. (Refer to p. 41 To register preset positions and p. 65 Camera Position Registration or Clearing.) 1. Select a system unit and monitor. (Refer to p. 31 System Unit Selection and p. 32 Monitor Selection.) 2. Enter a camera position number by pressing the numeric buttons. The entered number will appear on the LCD. Mon01 Cam001 ___11 F1 F2 F3 F4 3. Press the CAM POSI button. The registered camera and preset position will be selected, and the camera position image will be displayed on the active monitor. Mon01 C-P011 HD316 F1 F2 F3 F4 Mon02 Cam128 HD316 F1 F2 F3 F4 Mon02 Cam003 HD316 F1 F2 F3 F4 Mon02 Cam001 HD316 F1 F2 F3 F4 2. To return to the camera image more recently selected, press the + button while holding down the HISTORY button. The camera image more recently selected will be displayed on the monitor. (Camera 1 → 3 → 128) Mon02 Cam001 HD316 F1 F2 F3 F4 Mon02 Cam003 HD316 F1 F2 F3 F4 ■ Camera Selection Recall Every time you select a camera or camera position, this system controller memorizes up to 10 steps of camera selection. You can recall these operations in order or reverse order. In the following procedure, you can track back the camera images formerly displayed. Note: After power-off or system unit selection, the memorized camera operations will be cleared. In the following example, Camera 1 → 3 → 128 has been selected. 1. Press the - button while holding down the HISTORY button. The camera image formerly selected will be displayed on an active monitor. (Camera 128 → 3) Note: To recall camera images more formerly selected one by one, repeat pressing the - button while holding down the HISTORY button. (You can recall up to 10 camera images.) Mon02 Cam128 HD316 F1 F2 F3 F4 Note: To return to the camera images more recently selected one by one, repeat pressing the + button while holding down the HISTORY button. ■ Wiper Control The following procedure is available when a selected camera (housing) is equipped with a wiper. 1. Select a system unit, monitor, and desired camera. (Refer to p. 31 System Unit Selection, p. 32 Monitor Selection, and p. 32 Camera Selection.) 2. Keep pressing the WIPER button. The wiper will be activated while this button is being pressed. 42