Panasonic WVCU650 Operating Instructions - Page 66

6. Select a desired preset position number by performing either of the following. • Rotate the JogDial clockwise or counterclockwise. • Press the + or - button. Cam Posi Map 407 Cam-P016 C005 Pre32 Note: You can select a preset position number from 1 to 64. 7. Press the ENTER or CAM (SET) button. "Set OK?" will appear on the LCD. Cam Posi Map 407 Cam-P016 Set OK? Note: To cancel the setting, press the EXIT or MON (ESC) button. The LCD display will return to Step 6. 8. Press the ENTER or CAM (SET) button again. The specified camera channel and preset position number will be set for the selected camera position. "Memory" will appear on the LCD for a few seconds, and the LCD display will return to Step 1. Cam Posi Map 407 Cam-P016 Memory To delete a camera position 1. Select a camera position to delete by performing either of the following. • Rotate the JogDial clockwise or counterclockwise. • Press the + or - button. Cam Posi Map 407 Cam-P016 C005 Pre32 2. Press the CLEAR button. "Clear OK?" will appear on the LCD. Cam Posi Map 407 Cam-P016 Clear OK? Note: To cancel deleting the camera position, press the EXIT or MON (ESC) button. 3. Press the ENTER or CAM (SET) button. The camera position will be deleted. "Erased" will appear on the LCD for a few seconds, and the LCD display will return to Step 1. Cam Posi Map 407 Cam-P016 Erased 66 ● Associating Camera Numbers with Unit Numbers You can register camera-unit maps (the association of camera numbers and unit numbers). Up to 256 camera unit maps can be registered. You can select a camera by entering the camera channel alone, even if the camera is connected to system unit not currently selected. Note: If "Enable" is selected in Step 2, you can select only camera numbers associated with unit numbers. 1. Display "Cam-Unit Map" sub menu. (Refer to Step 1 to 4 of p. 51 To Recall Menu Functions.) Cam-Unit Map 408 Disable Enable Note: To disable camera-unit maps, display the "s" mark beside "Disable" by rotating the shuttle ring counterclockwise or moving the 3D joystick to the left. Cam-Unit Map 408 Disable Enable 2. Press the ENTER or CAM (SET) button. The camera-unit setting will appear on the LCD. Cam-Unit Map 408 Cam001 Unit01 3. Select a desired camera channel by performing one of the following. • Rotate the JogDial clockwise or counterclockwise. • Press the + or - button. • Enter the camera number with the numeric buttons. Cam-Unit Map 408 Cam016 Unit01 Notes: • To register a new position number, press the numeric buttons. • You can select a camera channel from 1 to 256. • The following are the factory default settings. Default settings of camera-unit maps Cam Unit 001 to 016 01 017 to 032 02 033 to 048 03 049 to 064 04 065 to 256 - - 4. Rotate the shuttle ring clockwise or move the 3D joystick to the right. The cursor will jump to the next item.