Pioneer DVR-660H-S Operating Instructions - Page 128
Additional information, Troubleshooting
UPC - 012562888897
View all Pioneer DVR-660H-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
17 Additional information • Levels separated by a bold line show where there is a noticeable change in picture quality. • Audio recording in all manual recording modes is in Dolby Digital 2 ch format, except for LPCM mode, which is in Linear PCM format. • See also Recording on page 34. Troubleshooting Incorrect operation is often mistaken for trouble and malfunction. If you think there is something wrong with this component, please check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after checking the points below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work. General Problem The disc is automatically ejected after closing the disc tray Can't eject a disc Remedy • Check that the disc is not an incompatible format disc (page 8). • Check that the disc is loaded properly (aligned in disc tray and labelside up). • Take out the disc and clean it (page 140). • Check that the disc has a region code compatible with the recorder. • Turn off the power to this device and press and hold OPEN/CLOSE on the front of the unit for more than three seconds. Can't play a disc • Check that the disc is a compatible format disc (page 8). • Take out the disc and clean it (page 140). • Check that the disc is loaded properly (aligned in disc tray and labelside up). • Press DVD to select the DVD. • There may be condensation in the recorder. Leave the recorder for an hour or so for the condensation to evaporate. • DVD+R/+RW discs recorded using another recorder with copyonce protected recordings will not play in this recorder. Can't record a disc Remote control does not work All settings are reset • Check that the disc is not an incompatible format disc (page 8). • Some DVD-RAM discs are not recordable until they have been initialized (page 50). This can take up to an hour. • If you connected this recorder to another Pioneer product using the CONTROL IN jack, point the remote control at the other component to use (page 15). • Set the remote control to the same ID number as the recorder (page 122). (When the batteries run down, the remote mode is automatically reset to Recorder1.) • Use the remote within its operating range (page 7). • Replace the batteries (page 7). • If the recorder is unplugged (or there is a power failure) while the recorder is on, all the settings will be lost. • Make sure that you switch the recorder into standby before unplugging the power cord. 128 En