Pioneer DVR-660H-S Operating Instructions - Page 136
Message, Explanation/Action
UPC - 012562888897
View all Pioneer DVR-660H-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
17 Additional information Message Explanation/Action • Repairing disc. • Repairing the HDD. During recording, the power was cut. This display appears when the power is restored. • Could not repair the disc. The recorder was unable to repair the disc after a power cut. The contents of the recording will be lost. • Overheating has stopped operation. Press DISPLAY to clear message. The internal temperature of the recorder has exceeded the operating limit. If this message reappears, please ask your nearest Pioneerauthorized service center or your dealer to carry out repairs. • HDD optimization is recommended. This can be done using Disc Setup. The HDD should be optimized (basically, HDD housekeeping) to maintain playback and recording performance. • Please perform HDD optimization. This can be done using Disc Setup. The HDD is in more urgent need of optimization in order to maintain performance. • The HDD has not been sufficiently optimized. Please optimize again. If this message appears repeatedly after optimizing the HDD it is likely that there is not enough free space on the HDD for optimization to complete properly. Please erase some titles from the HDD and optimize again. • An error occurred. Please consult the service center. Note that contents on the HDD may be erased when servicing this unit. This message is displayed when information from the HDD cannot be read. The HDD may be damaged or broken. Please ask your nearest Pioneer-authorized service center or your dealer to carry out repairs. • The Hard Disk Drive info is incorrect. Use the Disc Setup menu to reinitialize. As the HDD info cannot be properly read, no new recordings can be made. Reinitializing the HDD (page 109) may result in your being able to make recording again. Note that reinitializing the HDD will erase all recorded contents, including protected files. • There is no DV input or the input signal is unrecordable. No signal was detected at the DV IN jack. This may appear if a blank section of DV tape is playing in the connected camcorder. • No DV camcorder connected. The camcorder is not connected properly, or the camcorder is switched off. • You cannot connect more than one DV camcorder at a time. This recorder's DV jack supports connection to just one camcorder. • Cannot operate the DV camcorder. 136 En This recorder cannot operate the DV camcorder. Try switching off the camcorder then turn it back on again.