Sony HDR-UX20 Operating Guide - Page 23

b Notes • Disconnect the AC Adaptor from the DC IN jack holding both the camcorder and the DC plug. To remove the battery pack 1 Slide the POWER switch to OFF (CHG). 2 Press and hold the BATT (battery release) button and remove the battery pack in the direction of the arrow. BATT (battery release) button After a while, the approximate recordable time and battery information appear for about 7 seconds. You can view the battery information for up to 20 seconds by pressing DISP/BATT INFO again while the information is displayed. Remaining battery (approx.) Getting Started b Notes • When you remove the battery pack or disconnect the AC Adaptor, make sure that the (Movie) lamp/ (Still) lamp (p. 25)/ ACCESS lamp (p. 30)/access lamp (p. 32) is turned off. • When storing the battery pack, fully discharge the battery pack before storing it for an extended period (see page 131 for the details of storage). To use a power source from a wall outlet (wall socket) Make the same connections as you do when charging the battery pack. The battery pack will not lose its charge in this case. To check the remaining battery (Battery Info) Set the POWER switch to OFF (CHG), then press DISP/BATT INFO. Recording capacity (approx.) Charging time Approximate time (min.) required when you fully charge a fully discharged battery pack. Battery pack Charging time NP-FH50 135 NP-FH60 (supplied) 135 NP-FH70 170 NP-FH100 390 Available recording time Approximate time (min.) available when you use a fully charged battery pack. "HD" stands for high definition image quality, and "SD" stands for standard image quality. Continued , 23