Sony MZ-N1 Operating Instructions - Page 64

Messages If the following messages flash in the display window, check the messages below. Error message Meaning/Remedy BLANK • An MD with no recording on it is inserted. BUSY • You tried to operate the recorder while it was accessing the recorded data. , Wait until the message goes out (in rare cases, it may take a few minutes). Saving • The MD player is recording information (sounds) from the memory to the disc. , Wait until this process is completed. Do not expose the player to any physical shock, nor disrupt power supply. ERROR FULL HiDCin • Recording was not correctly done. , Place the recorder at a place with no vibrations and record again. • The disc is soiled with an oil film or finger prints, is scratched, or is not a standard disc. , Try recording again with another disc. • The recorder cannot read the disc information correctly. , Reinsert the disc. • The recorder cannot read the disc information correctly. , Insert another disc. , If it is no problem to erase the entire disc, do so (page 46). • The remaining recording time on the disc is 12 seconds (stereo), 24 seconds (LP2 stereo or monaural), 36 seconds (LP4 stereo), or less. , Replace the disc. • Voltage of the power supply is too high (The supplied AC power adaptor or the recommended car battery cord is not used). , Use the supplied AC power adaptor or the recommended car battery cord. HOLD • The recorder is locked. , Slide HOLD against the arrow to unlock the recorder (page 16, 49). LoBATT MEMORY • Battery is weak. , Replace the dry battery (page 15). • You tried to record with the recorder placed where it receives continuous vibration. , Put the recorder on a stable place, and start recording again. 64-GB