Sony STR-DN1010 Operating Instructions - Page 108
When you select PHASE, INFO., Select SAVE EXIT in step 2.
UPC - 027242779945
View all Sony STR-DN1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
2 View the measurement result. Press AMP and then press V/v repeatedly to select the item. Then press . Item and explanation EXIT Exits the setting process without saving the measurement results. LEVEL INFO. Displays the measurement result for speaker level. DIST. INFO. Displays the measurement result for speaker distance. PHASE INFO. Displays the phase of each speaker (in phase/out of phase). See "When you select "PHASE INFO."" (page 108). WARN CHECK Displays warning concerning the measurement results. See "Message list after Auto Calibration measurement" (page 43). SAVE EXIT Saves the measurement results and exits the setting process. RETRY Performs the Auto Calibration again. 3 Save the measurement result. Select "SAVE EXIT" in step 2. "COMPLETE" appears on the display and the settings are registered as selected position number. 4 Select the calibration type. Press V/v repeatedly to select CAL TYPE, then press . Calibration type and explanation FULL FLAT Makes the measurement of frequency from each speaker flat. ENGINEER Sets the frequency characteristics to a set that matches that of the Sony listening room standard. FRONT REF Adjusts the characteristics of all the speakers to match the characteristics of the front speaker. OFF Set the Auto Calibration to off. 108GB 5 Disconnect the optimizer microphone after you have finished. Note If you have reposition your speaker, we recommend that you perform Auto Calibration again to enjoy the surround sound. Tip The size of a speaker (LARGE/SMALL) is determined by the low frequency characteristics. The measurement results may vary, depending on the position of the optimizer microphone and speakers, and the shape of the room. It is recommended that you follow the measurement results. However, you can change those settings in the Speaker Settings menu. Save the measurement results first, then try to change the settings if you want. When you select "PHASE INFO." You can check the phase of each speaker (in phase/out of phase). 1 Press V/v repeatedly to select a speaker you want to check. Display and explanation xxx* : IN The speaker is in phase. xxx* : OUT The speaker is out of phase. The "+" and "-" terminals of the speaker may be connected the other way around. However, depending on the speakers, "xxx:OUT" appears on the display even though the speakers are connected properly. This is because of the speakers' specifications. In this case, you can continue to use the receiver. * xxx represent a speaker channel. FL Front left FR Front right CNT Center SL Surround left SR Surround right SBL Surround back left SBR Surround back right LH Front left high RH Front right high SW Subwoofer Depending on the measurement result, the speaker channel may not appears.