Sony STR-DN1010 Operating Instructions - Page 93

3 Press V/v repeatedly to set the size of the selected speaker, then press . • Large If you connect large speakers that will effectively reproduce bass frequencies, select "Large". Normally, select "Large". • Small If the sound is distorted, or you feel a lack of surround effects when using multi channel surround sound, select "Small" to activate the bass redirection circuitry and output the bass frequencies of each channel from the subwoofer or other "Large" speakers. Note This function does not work when "Analog Direct" is being used. Tips • The "Large" and "Small" settings for each speaker determine whether the internal sound processor will cut the bass signal from that channel. When the bass is cut from a channel, the bass redirection circuitry sends the corresponding bass frequencies to the subwoofer or other "Large" speakers. However, since bass sound has a certain amount of directionality, it is best not to cut it, if possible. Therefore, even when using small speakers, you can set them to "Large" if you want to output the bass frequencies from that speaker. On the other hand, if you are using a large speaker, but prefer not to have bass frequencies output from that speaker, set it to "Small". If the overall sound level is lower than you prefer, set all speakers to "Large". If there is not enough bass, you can use the equalizer to boost the bass levels. • The surround back speakers will be set to the same setting as that of the surround speakers. • When the front speakers are set to "Small", the center, surround, and front high speakers are also automatically set to "Small". • If you do not use the subwoofer, the front speakers are automatically set to "Large". Crossover Frequency (Speaker crossover frequency) Lets you set the bass crossover frequency of speakers that the speaker size has been set to "Small" in the Speaker Settings menu. Measured speaker crossover frequency is set for each speaker after the Auto Calibration. 1 Press V/v repeatedly to select the speaker on the screen you want to adjust, then press . 2 Press V/v repeatedly to adjust the value, then press . Test Tone You can select the test tone type on the "Test Tone" screen. Tips • To adjust the level of all speakers at the same time, press MASTER VOL +/-. You can also use MASTER VOLUME on the receiver. • The adjusted value is shown on the TV screen during adjustment. To output test tone from each speaker You can output test tone from the speakers in sequence. 1 Press B/b repeatedly to select "Test Tone", then press . 2 Press V/v repeatedly to adjust the parameter, then press . • OFF • AUTO The test tone is output from each speaker in sequence. • FL, CNT, FR, SR, SB, SBR, SBL, SL, LH, RH, SW You can select which speakers will output the test tone. 3 Press V/v repeatedly to adjust the speaker level, then press . continued 93GB Advanced Operations