Symantec 360R Administration Guide - Page 20

20 Administering the security gateway Managing the security gateway using the serial console 6 In the terminal program, set the program to connect directly to the COM port on your computer to which the appliance is physically connected. 7 Set the communication settings as follows: Baud (Bits per second) Data bits Parity Stop bits Flow control 9600 8 None 1 None 8 Connect to the appliance. 9 After the terminal has connected to the appliance, on the rear panel of the appliance, quickly press the reset button. 10 At the prompt, do one of the following: Local IP Address Type 1 to change the IP address of the appliance. Local Network Mask Type 2 to change the netmask of the appliance. DHCP Server Type 3 to enable or disable the DHCP server feature of the appliance.