Yamaha RX V661 MCXSP10 Manual - Page 59
<XM>123
UPC - 027108927411
View all Yamaha RX V661 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
BASIC OPERATION XM Satellite Radio tuning Before performing operations, set the operation mode selector on the remote control to KSOURCE. ■ All Channel Search mode 1 Press 2SEARCH MODE (or NSRCH MODE) repeatedly to select "ALL CH SEARCH". 3 Press 5PRESET/TUNING/CH l / h (or DPRESET/CH k / n) repeatedly to change the preset channel number (1 to 8). y You can also select the preset channel number directly by pressing the numeric buttons (1 to 8) (B). ■ Direct number access mode 2 Press 5PRESET/TUNING/CH l / h (or DPRESET/CH k / n) repeatedly to search for a channel within all channels. y • You can search for a channel quickly by pressing and holding 5PRESET/TUNING/CH l / h (or DPRESET/CH k / n). • To display the XM Radio ID number displayed in the front panel display, select channel "0". ■ Category Search mode 1 Press 2SEARCH MODE (or NSRCH MODE) repeatedly to select "CAT SEARCH". 1 Press NSRCH MODE on the remote control repeatedly to select "ALL CH SEARCH" or "CAT SEARCH". 2 Press the numeric buttons (B) to enter the desired three-digit channel number. For example, to enter the number 123, press the numeric buttons (B) as shown below. CLASSICAL 1 LIVE/CLUB 2 ENTERTAIN 3 The display changes as follows. 2 Press 4CATEGORY (or DA-E/CAT. l / h) repeatedly to change the channel category. 3 Press 5PRESET/TUNING/CH l / h (or DPRESET/CH k / n) repeatedly to search for a channel within the selected channel category. y You can search for a channel quickly by pressing and holding 5PRESET/TUNING/CH l / h on the front panel (or DPRESET/CH k / n on the remote control). ■ Preset Search mode Prior to selecting a preset channel in the Preset Search mode, you must preset XM Satellite Radio channels. For details, see "Setting the XM Satellite Radio preset channels" on page 56. y The initial factory setting of all preset channels (A1 to E8) is "[001] Preview". 1 Press 2SEARCH MODE (or NSRCH MODE) repeatedly to select "PRESET SEARCH". 2 Press 4CATEGORY (or DA-E/CAT. l / h) repeatedly to change the preset channel group (A to E). --1 -12 123 y • To enter a one-digit or two-digit channel number, press the numeric buttons (B) on the remote control and then press MENT to confirm the input number. • Instead of pressing MENT to tune into the channel immediately, you can wait a few seconds until this unit confirms the entered channel number. • If no button is pressed within a few seconds after you enter a one-digit or two-digit number, this unit automatically confirms the entered channel number. • Pressing a button other than the numeric buttons (B) or MENT cancels the Direct Number Access mode procedure. English 55 En