Autodesk 00308-011408-9F30A User Guide - Page 116
Entering a Point at a Symbol Basepoint
![]() |
UPC - 606121128243
View all Autodesk 00308-011408-9F30A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 116 highlights
NOTE Midpoint snap cannot be used to enter a point at the center of an arc or circle. You must use Centerpoint snap to accomplish this. For more information, see page 109. To enter a point at the midpoint of an entity 1 While in a drawing mode, activate Midpoint snap on the Snaps toolbar. 2 Click the entity. TIP Midpoint snap is the same as Jump snap set to 50%. Entering a Point at a Symbol Basepoint AutoPoint indicator Basepoint snap allows you to enter a point at the basepoint of an existing symbol. As you move the pointer over the drawing, a diamond-shaped AutoPoint Indicator identifies the basepoint of any symbol you pass over. To enter a point at the basepoint of an existing symbol 1 While in a drawing mode, activate Basepoint snap on the Snaps toolbar. 2 Click the symbol. 106 | Chapter 9 Entering & Modifying Points
![](/manual_guide/products/autodesk-003080114089f30a-user-guide-98ffd41/116.png)