Autodesk 00308-011408-9F30A User Guide - Page 300
Removing s of Entities
UPC - 606121128243
View all Autodesk 00308-011408-9F30A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 300 highlights
3 Click the entity you want to trim to the edge entity. Click the portion of the entity you want to keep, near the point where it intersects the edge entity. TIP Press ESC or right-click once to select another edge by repeating step 2. Removing Sections of Entities AutoSketch provides two methods to remove a section from a line, arc, circle, or polyline. s Break creates a gap in an entity by clicking a single point at the center of the gap. s Channel creates a trimming path that removes sections from one or more entities at the edges of the channel. Removing a section from an entity, either by breaking or channeling, results in two separate entities which can be selected or edited independently. NOTE Break and Channel will not effect polygons with holes (produced using the Union, Intersection, or Difference). To remove a section from a single entity 1 On the Edit menu, click Trim, Break, or click the Break button on the All- In-One toolbar. 2 Click the entity you want to break. The entity is highlighted. 3 (optional) Enter a different length in the Gap Width text box on the edit bar to specify the length of the break opening and press ENTER. A rubberband line representing the width of the gap appears and follows the pointer. 4 Enter the point for the break, this is the center of the gap. AutoSketch removes the section from the entity, leaving two separate entities. 290 | Chapter 23 Trimming Entities