Autodesk 00308-011408-9F30A User Guide - Page 125
X-axis, While in a drawing mode, type
UPC - 606121128243
View all Autodesk 00308-011408-9F30A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
the letter that appears on the button. The X-axis and Y-axis lock modifiers must be activated before each point. However, the Orthogonal and Normal lock modifiers remain active until you type U on the keyboard. A list of the letters used to apply lock modifiers appears on page 101. NOTE X-axis, Y-axis, and Orthogonal lock modifiers reference grid lines-as the grid is rotated so too are the reference lines for the lock modifiers. For more information, see "Setting Up the Grid" on page 61. To enter a point aligned horizontally with the last point. 1 While in a drawing mode, type X to apply the X-axis lock modifier, or click the X-axis lock modifier button on the All-In-One toolbar. 2 Enter the point using any snap. To enter a point aligned vertically with the last point 1 While in a drawing mode, type Y to apply the Y-axis lock modifier, or click the Y-axis lock modifier button on the All-In-One toolbar. 2 Enter the point using any snap. Using Lock Modifiers | 115