Brother International MFC-4300 Users Manual - English - Page 61

Manual Transmission Manual transmission lets you hear the dial tone, ringing and fax receiving tones before sending the fax. 1 Place the original face down in the ADF. 2 Pick up the handset and listen for a dial tone-OR-press Hook and listen for a dial tone. 3 Enter the fax number you want to call. (You can enter the digits using the dial pad, or you can enter a One Touch or Speed Dial number or you can call using Search.) (See One Touch Dialing, page 7-4.) 4 When you hear the fax tone, press Start. 5 If you're using the handset, hang up. Automatic Transmission This is the easiest way to send a fax. IMPORTANT: Do not pick up the handset, or press Hook. 1 Place the original face down in the ADF. 2 Enter the fax number using One Touch, Speed Dial, Search or the dial pad. (See Speed Dialing, page 7-5.) 3 Press Start. Manual and Automatic Fax Redial If you're sending a fax manually and the line is busy, after you disconnect the call press Redial/Pause to retry the number. If you're sending a fax automatically and the line is busy, the MFC will automatically redial up to three times at 5 minute intervals. Dual Access You can scan up to 50 originals into the fax memory, even while the MFC is receiving or sending another fax (from memory). You can set temporary settings for each fax you're scanning, except Timer and Polling. If you try to scan in and store a 51st fax, the MFC will send it immediately, without storing it in memory. If you get a MEMORY FULL message while scanning the first page of a fax, press Stop to cancel scanning. If you get a MEMORY FULL message while scanning in a subsequent page, you'll have the option to press Start to transmit the pages scanned so far, or to press Stop to cancel the operation. 1 Make sure the ADF is empty. 2 Place the original in the ADF. SETUP SEND 6-2