Brother International MFC-4300 Users Manual - English - Page 80

Remote Commands Follow the commands below to access features remotely. When you call the MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system will signal you with two short beeps to enter a remote command. Remote Commands Operation Details 95 Changing Fax Forwarding / Paging setting 1 OFF 2 Fax Forwarding 3 Paging 4 FAX FWD No. 6 Fax Storage ON 7 Fax Storage OFF If you hear one long beep, the change is accepted. If you hear three short beeps, you cannot change it because the conditions have not been met (Example: registering paging number). You can register your fax forwarding number by using 4. FAX FWD NO (see p. 8-1). Once you have registered the number, the MFC will change automatically to FAXFWD:ON mode. Then retrieve a Memory Status List by entering 961 (see p. 8-5) to make sure that the Fax Forwarding number you registered is correct in the List. You can set FAX STORAGE to ON or OFF. 96 Retrieve a fax 1 Memory Status List Enter the number of a remote fax machine to 2 Retrieve all faxes receive the Memory Status List or stored fax message(s). (See p. 8-5) 3 Erase fax from the If you hear one long beep, you can erase fax memory message(s) from the memory. 97 Check the Receiving Status 1 FAX You can check whether your MFC has received any faxes. If yes, you will hear one long beep. If no, you will hear three short beeps. 98 Change Receive Mode 1 TAD 2 FAX/TEL 3 FAX If you hear one long beep, you can change the Receive Mode. If you hear three short beeps, you cannot change it. 90 Exit After a long beep, you can exit remote access. 8-4 REMOTE FAX OPTIONS