Canon EOS C300 Instruction Manual - Page 109
Special Rec], Activating Slow & Fast Motion Mode and Recording
View all Canon EOS C300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
Special Recording Modes Activating Slow & Fast Motion Mode and Recording 1 Open the [Special Rec] submenu. [w Other Functions] > [Special Rec] 2 Select [Slow & Fast Motion] and then press SET. • [S&F STBY] appears at the top of the screen. • The selected shooting frame rate appears on the right of the screen next to the frame rate setting (the playback frame rate). Shooting frame rate [w Other Functions] [Special Rec] [Off] 109 Playback frame rate 3 Press the START/STOP button to begin recording. • The tally lamp illuminates. • [S&F STBY] changes to [Ü S&F REC] while recording. 4 Press the START/STOP button again to stop recording. • The clip is recorded at the selected frame rate. • The tally lamp goes out and [S&F STBY] appears at the top of the screen. NOTES • This special recording mode is not available when [w Other Functions] > [Bit Rate/Resolution] is set to [35 Mbps 1440x1080]. Also, you can use only one special recording mode at a time. In addition, slow & fast motion mode cannot be used with double slot recording. • While recording, you cannot change the shooting frame rate. • For lower shooting frame rates, it may take approximately 1 second to stop recording. • Slow & fast motion mode will be deactivated if the special recording mode is changed or turned off. It will be deactivated also if you change the video configuration. • When the bit rate is set to 50 Mbps (A 59), relay recording is not available during slow motion recording. • During this special recording mode, the running mode of the time code (A 84) can be set to [Rec Run] or [Regen.] and the time code advances by the number of frames recorded. If the running mode of the time code is set to [Free Run] or the time code is input from an external source, the running mode will switch to [Rec Run] during special recording mode. When special recording mode is deactivated, the running mode will return to its previous setting. • During special recording mode, the time code signal will not be output from the TIME CODE terminal or HD/SD SDI terminal.