Canon REALiS LCOS WUX10 Mark II D Multimedia Projector WUX10 MarkII Users Manu - Page 126
Replacing the Lamp, the screw.
View all Canon REALiS LCOS WUX10 Mark II D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Maintenance ■Replacing the Lamp 1 Turn off the projector, disconnect the power plug from the AC outlet, and let the projector stand for at least 1 hour. 2 Loosen a screw with a flathead screw- driver and remove the lamp cover. 3 Loosen two screws, pull up the handle, and then remove the lamp. Handle Lamp cover Screw Screw 4 Fully insert a new lamp and secure it with two screws. * After the installation, be sure to push down the handle. 5 Replace the lamp cover and tighten the screw. 6 Turn on the projector. 7 Bring up the menu and select [System settings] -> [Other settings] -> [Lamp counter]. (P101) 8 Select [Reset] -> [OK] to reset the lamp counter. Lamp Lamp cover 126
Maintenance
126
■
Replacing the Lamp
1
Turn off the projector, disconnect the
power plug from the AC outlet, and let
the projector stand for at least 1 hour.
2
Loosen a screw with a flathead screw-
driver and remove the lamp cover.
3
Loosen two screws, pull up the handle,
and then remove the lamp.
4
Fully insert a new lamp and secure it
with two screws.
*
After the installation, be sure to
push down the handle.
5
Replace the lamp cover and tighten
the screw.
6
Turn on the projector.
7
Bring up the menu and select [System
settings] -> [Other settings] -> [Lamp
counter]. (
P101
)
8
Select [Reset] -> [OK] to reset the
lamp counter.
Lamp cover
Screw
Screw
Lamp
Handle
Lamp cover