Canon REALiS LCOS WUX10 Mark II D Multimedia Projector WUX10 MarkII Users Manu - Page 55
Adjusting Keystone Distortion, Auto adjustment
View all Canon REALiS LCOS WUX10 Mark II D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Projecting an Image < Adjusting Image Adjusting Keystone Distortion The D.SHIFT/KEYSTONE button corrects the keystone distortion. • Keystone can be adjusted within the range of ± 20 degrees. If the keystone distortion is too large to adjust, move the projector installation position. (P33) • The amount of adjustment may be smaller depending on type of input signal. • The result of keystone adjustment is memorized. If you place the projector at the same position, the keystone adjustment is not necessary. • Signals are processed digitally when keystone distortion is corrected. The image may look different from the original one. In addition, the aspect ratio of the image may change. • If you select [16:9 D. image shift] or [4:3 D. image shift] for [Screen aspect], the keystone adjustment will be disabled. Project the image at right angle to the screen. The keystone adjustment is not performed under the some other conditions. For the details, refer to the next page. ■Auto adjustment Press the D.SHIFT/KEYSTONE button, and then the AUTO SET button. ■Manual adjustment 1 Press the D.SHIFT/KEYSTONE button to pop up a window shown at the lower right. Remote control Top control 2 Press the pointer buttons to adjust the focus. Remote control Top control [ ]: Reduces the length of the upper edge. < [ ]: Reduces the length of the lower edge. 55