Cisco ACE-4710-K9 Administration Guide - Page 273
Assigning a Priority to the Standby FT Group Member, priority, peer priority
View all Cisco ACE-4710-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 273 highlights
Chapter 7 Configuring Redundant ACE Appliances Configuring Redundancy To configure the priority of an FT group on the active member, use the priority command in FT group configuration mode. You must configure the priority of an FT group on both appliances. Configure a higher priority for the group on the ACE where you want the active member to initially reside. The syntax of this command is: priority number The number argument specifies the priority of the FT group on the local peer. Enter an integer from 1 to 255. The default is 100. Tip Configure a higher priority on the FT group member that you want to be the active member. For example, to configure the priority of the FT group on the active member, enter: host1/Admin(config-ft-group)# priority 150 To restore the default priority of 100, enter: host1/Admin(config-ft-group)# no priority Assigning a Priority to the Standby FT Group Member To configure the priority of an FT group on the remote standby member, use the peer priority command in FT group configuration mode. You must configure the priority of an FT group on both redundant appliances. Configure a lower priority for the FT group on the ACE where you want the standby member to initially reside. The syntax of this command is: peer priority number The number argument specifies the priority of the FT group on the standby member. Enter an integer from 1 to 255. The default is 100. Tip Configure a lower priority on the FT group member that you want to be the standby member. OL-11157-01 Cisco 4700 Series Application Control Engine Appliance Administration Guide 7-21