Cisco ACE-4710-K9 Administration Guide - Page 60
Configuring Virtual Terminal Line Settings, line vty, session-limit, clear line
View all Cisco ACE-4710-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Configuring Terminal Settings Chapter 1 Setting Up the ACE Configuring Virtual Terminal Line Settings Virtual terminal lines allow remote access to the ACE. A virtual terminal line is not associated with the console port; instead, it is a virtual port that allows you to access the ACE. Use the line vty configuration mode command to configure the virtual terminal line settings. The CLI displays the line configuration mode. Use the session-limit command to configure the maximum number of terminal sessions per line. The syntax for this command is as follows: session-limit number The number argument configures the maximum number of terminal sessions per line. The range is from 1 to 251. For example, to configure a virtual terminal line, enter: host1/Admin# config Enter configuration commands, one per line. End with CNTL/Z host1/Admin(config)# host1/Admin(config)# line vty host1/Admin(config-line)# session-limit 23 To disable a setting for the configured virtual terminal line, use the no form of the command. For example: host1/Admin(config-line)# no session-limit 23 Use the clear line command in Exec mode to close a specified vty session. The syntax for this command is as follows: clear line vty_name The vty_name argument specifies the name of the VTY session. Enter a maximum of 64 characters for the name of the virtual terminal. For example, to close a specified vty session, enter: host1/Admin# clear line vty vty1 1-34 Cisco 4700 Series Application Control Engine Appliance Administration Guide OL-11157-01