Cisco ACE-4710-K9 Administration Guide - Page 310

Clearing Redundancy Statistics Chapter 7 Configuring Redundant ACE Appliances Clearing Redundancy Statistics To clear redundancy statistics, use the commands described in the following sections. Note If you configure redundancy on the ACE, then you must explicitly clear statistics on both the active and the standby ACEs. Clearing statistics on the active appliance only does not clear the statistics on the standby appliance. Clearing FT Statistics To clear redundancy heartbeat statistics, use the clear ft stats command in Exec mode. When you enter this command for the first time, the ACE sets the FT statistics counters to zero and stores a copy of the latest statistics locally. From that point on, when you enter the show ft stats command, the ACE displays the difference between the statistics stored locally and the current statistics. The syntax of this command is: clear ft stats For example, enter: host1/Admin# clear ft stats Clearing the Redundancy History To clear the redundancy history, use the clear ft history command in Exec mode in the Admin context only. The syntax of this command is: clear ft history {cfg_cntlr | ha_dp_mgr | ha_mgr} The keywords are: • cfg_cntlr-Clears the Config Controller debug log • ha_dp_mgr-Clears the HA (redundancy) dataplane manager debug log • ha_mgr-Clears the HA (redundancy) manager debug log For example, enter: host1/Admin# clear ft history cfg_cntlr 7-58 Cisco 4700 Series Application Control Engine Appliance Administration Guide OL-11157-01