Cisco ACE-4710-K9 Administration Guide - Page 71
Task and Command Example, Table 2-1, Remote Network Management Configuration, Quick Start continued
View all Cisco ACE-4710-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Chapter 2 Enabling Remote Access to the ACE Remote Access Configuration Quick Start Table 2-1 Remote Network Management Configuration Quick Start (continued) Task and Command Example 4. Configure a policy map that activates the SSH and Telnet management protocol classifications. host1/Admin(config)# policy-map type management first-match REMOTE_MGMT_ALLOW_POLICY host1/Admin(config-pmap-mgmt)# class SSH-ALLOW_CLASS host1/Admin(config-pmap-mgmt-c)# permit host1/Admin(config-pmap-mgmt-c)# exit host1/Admin(config-pmap-mgmt)# class TELNET-ALLOW_CLASS host1/Admin(config-pmap-mgmt-c)# permit host1/Admin(config-pmap-mgmt-c)# exit host1/Admin(config-pmap-mgmt)# exit host1/Admin(config)# 5. Attach the traffic policy to a single VLAN interface or globally to all VLAN interfaces in the same context. For example, to specify an interface VLAN and apply the remote management policy map to the VLAN, enter: host1/Admin(config)# interface vlan 50 host1/Admin(config-if)# ip address 172.16.1.100 255.255.0.0 host1/Admin(config-if)# service-policy input REMOTE_MGMT_ALLOW_POLICY host1/Admin(config-if)# exit 6. (Optional) Configure the maximum number of Telnet sessions allowed for each context. host1/Admin(config)# telnet maxsessions 3 7. (Optional) Configure the maximum number of SSH sessions allowed for each context. host1/Admin(config)# ssh maxsessions 3 OL-11157-01 Cisco 4700 Series Application Control Engine Appliance Administration Guide 2-3