Cisco ACE-4710-K9 Administration Guide - Page 32
Step 12, running-configuration file. This is the default.
View all Cisco ACE-4710-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Using the Setup Script to Enable Connectivity to the Device Manager Chapter 1 Setting Up the ACE policy-map type management first-match first-match remote_mgmt_allow_policy class remote_access permit interface vlan 2 ip address 192.168.1.10 255.255.255.0 access-group input ALL service-policy input remote_mgmt_allow_policy no shutdown ip route 0.0.0.0 0.0.0.0 172.16.2.1 Step 12 Step 13 Step 14 At the prompt "Would you like to edit the configuration? (yes/no) [n]:", enter one of the following replies: • Type y to modify the configuration at the CLI. • Type n to accept the configuration without any additional changes. This setting is the default. At the prompt "Use this configuration? (yes/no) [y]":, enter one of the following replies: • Type y to instruct the ACE to boot using the newly created running-configuration file. This is the default. • Type n to bypass using the newly created running-configuration file and boot with an empty configuration. At the prompt "Would you like to save the running-config to startup-config? (yes/no) [n]:, enter one of the following replies: • Type y to save the running-configuration to the startup-configuration file. • Type n to bypass saving the running-configuration to the startup-configuration file. Cisco 4700 Series Application Control Engine Appliance Administration Guide 1-6 OL-11157-01