Cisco ACE-4710-K9 Administration Guide - Page 388
Enabling the Display of Raw XML Request show Command Output in XML Format
View all Cisco ACE-4710-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 388 highlights
Chapter 9 Configuring the XML Interface Enabling the Display of Raw XML Request show Command Output in XML Format REVIEW DRAFT - CISCO CONFIDENTIAL Enabling the Display of Raw XML Request show Command Output in XML Format By default, XML responses will automatically appear in XML format if the corresponding CLI show command output supports the XML format. However, if you are running commands on the CLI console or you are running raw XML responses from NMS, the XML responses appear in regular CLI display format. You can enable the display of raw XML request show command output in XML format by performing one of the following actions: • Specifying the xml-show on command in Exec mode from the CLI, or • Including the xml-show on command in the raw XML request itself (CLI commands included in an XML wrapper). Specification of the xml-show on command is not required if you are running true XML (as shown in the example below). For details on the show command output supported in XML format, consult the ACE DTD file, ace_appliance.dtd, that is included as part of the software image (see the "Accessing the ACE DTD File" section). The ACE DTD File contains the information on the XML attributes for those show commands whose output supports XML format. For example, if you specify the show interface vlan 10 command, the DTD for the show interface command appears as follows: The XML representation of the show interface command appears as follows: 9-24 Cisco 4700 Series Application Control Engine Appliance Administration Guide OL-11157-01