Cisco ACE-4710-K9 Administration Guide - Page 67
Displaying the ACE Boot Configuration, Restarting the ACE - failed to save configuration
View all Cisco ACE-4710-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Chapter 1 Setting Up the ACE Restarting the ACE Displaying the ACE Boot Configuration To display the current BOOT environment variable and configuration register setting, use the show bootvar command in Exec mode. For example, to display the BOOT environment variable settings, enter: host1/Admin# show bootvar BOOT variable = "image:/c4710ace-mz.3.0.0_AB0_0.488.bin;image:/c4710ace-mz.3.0.0 _AB0_0.453.bin" Configuration register is 0x1 Restarting the ACE To reboot the ACE directly from its CLI and reload the configuration, use the reload command in Exec mode. The reload command reboots the ACE and performs a full power cycle of both the hardware and software. The reset process can take several minutes. Any open connections with the ACE are dropped after you enter the reload command. Caution Configuration changes that are not written to the Flash partition are lost after a reload. Before rebooting, enter the copy running-conf startup-config command in Exec mode to store the current configuration in Flash memory. If you fail to save your configuration changes, the ACE reverts to its previous settings upon restart. When you specify reload, the ACE prompts you for confirmation and performs a cold restart of the ACE: host1/Admin# reload This command will reboot the system Save configurations for all the contexts. Save? [yes/no]: yes Generating configuration.... running config of context Admin saved Perform system reload. [yes/no]: [yes] yes OL-11157-01 Cisco 4700 Series Application Control Engine Appliance Administration Guide 1-41