D-Link DES-3010G Reference Manual - Page 134
ARP Commands, show arpentry
View all D-Link DES-3010G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 134 highlights
DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual 23 ARP COMMANDS The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command show arpentry config arp_aging time clear arptable Parameters {ipif | ipaddress | static} Each command is listed, in detail, in the following sections. show arpentry Purpose Syntax Description Parameters Restrictions Used to display the ARP table. show arpentry {ipif | ipaddress | [static] This command is used to display the current contents of the Switch's ARP table. − The name of the IP interface the end node or station for which the ARP table entry was made, resides on. − The network address corresponding to the IP interface name above. static − Displays the static entries to the ARP table. None. Example Usage: To display the ARP table: 132