D-Link DES-3010G Reference Manual - Page 60
local use 1
![]() |
View all D-Link DES-3010G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual config syslog host Restrictions 10 security/authorization messages 11 FTP daemon 12 NTP subsystem 13 log audit 14 log alert 15 clock daemon 16 local use 0 (local0) 17 local use 1 (local1) 18 local use 2 (local2) 19 local use 3 (local3) 20 local use 4 (local4) 21 local use 5 (local5) 22 local use 6 (local6) 23 local use 7 (local7) local0 − Specifies that local use 0 messages will be sent to the remote host. This corresponds to number 16 from the list above. local1 − Specifies that local use 1 messages will be sent to the remote host. This corresponds to number 17 from the list above. local2 − Specifies that local use 2 messages will be sent to the remote host. This corresponds to number 18 from the list above. local3 − Specifies that local use 3 messages will be sent to the remote host. This corresponds to number 19 from the list above. local4 − Specifies that local use 4 messages will be sent to the remote host. This corresponds to number 20 from the list above. local5 − Specifies that local use 5 messages will be sent to the remote host. This corresponds to number 21 from the list above. local6 − Specifies that local use 6 messages will be sent to the remote host. This corresponds to number 22 from the list above. local7 − Specifies that local use 7 messages will be sent to the remote host. This corresponds to number 23 from the list above. udp_port − Specifies the UDP port number that the syslog protocol will use to send messages to the remote host. ipaddress − Specifies the IP address of the remote host where syslog messages will be sent. state [enable | disable] − Allows the sending of syslog messages to the remote host, specified above, to be enabled and disabled. Only administrator-level users can issue this command. Example usage: To configure a syslog host: DES-3026:4#config syslog host all severity all facility local0 Command: config syslog host all severity all facility local0 58
![](/manual_guide/products/dlink-des3010g-reference-manual-5af1315/60.png)