D-Link DES-3010G Reference Manual - Page 58
create syslog host, Command: create syslog host 1 ipaddress 10.53.13.94 severity all facility local0
View all D-Link DES-3010G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual create syslog host Restrictions 21 local use 5 (local5) 22 local use 6 (local6) 23 local use 7 (local7) local0 − Specifies that local use 0 messages will be sent to the remote host. This corresponds to number 16 from the list above. local1 − Specifies that local use 1 messages will be sent to the remote host. This corresponds to number 17 from the list above. local2 − Specifies that local use 2 messages will be sent to the remote host. This corresponds to number 18 from the list above. local3 − Specifies that local use 3 messages will be sent to the remote host. This corresponds to number 19 from the list above. local4 − Specifies that local use 4 messages will be sent to the remote host. This corresponds to number 20 from the list above. local5 − Specifies that local use 5 messages will be sent to the remote host. This corresponds to number 21 from the list above. local6 − Specifies that local use 6 messages will be sent to the remote host. This corresponds to number 22 from the list above. local7 − Specifies that local use 7 messages will be sent to the remote host. This corresponds to number 23 from the list above. udp_port − Specifies the UDP port number that the syslog protocol will use to send messages to the remote host. ipaddress − Specifies the IP address of the remote host where syslog messages will be sent. state [enable | disable] − Allows the sending of syslog messages to the remote host, specified above, to be enabled and disabled. Only administrator-level users can issue this command. Example usage: To create syslog host: DES-3026:4#create syslog host 1 ipaddress 10.53.13.94 severity all facility local0 Command: create syslog host 1 ipaddress 10.53.13.94 severity all facility local0 Success. DES-3026:4# config syslog host Purpose Syntax Description Used to configure the syslog protocol to send system log data to a remote host. config syslog {host [all ]} {severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port | ipaddress | state [enable | disable]} The config syslog host command is used to configure the syslog t l t d t l i f ti t th t 56