D-Link DES-3010G Reference Manual - Page 51
Network Monitoring Commands, show packet ports - size
View all D-Link DES-3010G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
DES-3010F / DES-3010G / DES-3018 / DES-3026 Layer 2 Switch CLI Reference Manual 8 NETWORK MONITORING COMMANDS The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command show packet ports show error ports show utilization clear counters clear log show log enable syslog disable syslog show syslog create syslog host config syslog delete syslog host show syslog host Parameters [cpu | ports {}] {ports } {index } ipaddress {severity [informational | warning | all | facility [local0 | local1| local2 | local3 | local4 | local5 | local6 | local7] | udp_port state [enable | disable] {host [all ]} {severity [informational | warning | all] | facility [local0 | local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port | ipaddress | state [enable | disable]} [ | all] {} Each command is listed, in detail, in the following sections. show packet ports Purpose Syntax Description Parameters Restrictions Used to display statistics about the packets sent and received by the Switch. show packet ports This command is used to display statistics about packets sent and received by ports specified in the port list. The results are separated into three tables, labeled A, B, and C in the window above. Table A is relevant to the size of the packets, Table B is relevant to the type of packets and Table C is relevant to the type of frame associated with these packets. − Specifies a port or range of ports to be displayed. None. Example usage: To display the packets analysis for port 7: 49