D-Link DSR-1000AC User Manual - Page 114

Section 7 - VPN Tunnel Mode Path: VPN > IPSec VPN > Tunnel Mode When tunnel mode is selected, you can enable NetBIOS and DHCP over IPSec. DHCP over IPSec allows this router to serve IP leases to hosts on the remote LAN. You can also define a single IP address, a range of IPs, or a subnet on both the local and remote private networks that can communicate over the tunnel. The router allows full tunnel and split tunnel support. Full tunnel mode just sends all traffic from the client across the VPN tunnel to the router. Split tunnel mode only sends traffic to the private LAN based on pre-specified client routes. These client routes give the client access to specific private networks, thereby allowing access control over specific LAN services. 1. Click VPN > IPSec VPN > Tunnel Mode. 2. Complete the fields in the table below and click Save. Field Tunnel Mode Start/End IP Address Primary/Secondary DNS Primary/Secondary WINS Save Select either Full Tunnel or Split Tunnel. Enter the starting and ending IP addresses. Description Enter the primary and secondary DNS server addresses. Enter the primary and secondary WINS server addresses. Click Save to save and activate your settings. D-Link DSR-Series User Manual 101