Dell Latitude CP Replacement Instructions - Page 25

metal tabs (2) keyboard plastic tabs (2) scalloped edge of blank key palmrest deflect palmrest outward to release keyboard 5. Once the keyboard is fully released from the palmrest, place the keyboard upside down over the touch pad. 6. Disconnect the keyboard cable from connector KB1 on the system board. 7. Remove the keyboard assembly. Follow these steps when replacing the keyboard assembly: 1. Connect the keyboard cable to connector KB1 on the system board. 2. Fit the left edge of the keyboard into place, making sure the two small metal tabs on the keyboard fit under the corresponding plastic tabs on the palmrest's inner edge. 3. Lower the right edge of the keyboard into place, and press on the blank key below the key until the tab on the palmrest's inner edge engages the keyboard with an audible "click." 4. Check that the keyboard is correctly installed. The keys should be flush with the left and right surfaces of the palmrest. 5. Reinstall the six 12-mm screws. Dell Latitude CP and CPi - Parts Removal and Replacement Guide 19