Dell Latitude CP Replacement Instructions - Page 7

Dell™ Latitude™ CP and CPi Parts Removal and Replacement Guide

Page 7 highlights

This guide provides instructions for removing and replacing field-replaceable components, assemblies, and subassemblies. Unless otherwise noted, each procedure in this guide assumes the following: The computer and any attached peripherals are turned off, and the peripherals are disconnected from the I/O panel on the back of the computer. A part can be replaced by performing the removal procedure in reverse order. When the display assembly is open nearly 180 degrees, use a book or something similar to support it. The angle of the display assembly with respect to the bottom case should never be allowed to exceed 180 degrees. Also, when performing the procedures in this guide, the locations or directions relative to the computer are as shown in Figure 1 unless otherwise specified. back of computer left side right side front of computer Dell Latitude CP and CPi - Parts Removal and Replacement Guide 1

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58

Dell Latitude CP and CPi
Parts Removal and Replacement Guide
1
·µ¸¸¹º»¼´½´¾¿µ¹º±Àº¼³¿º±À½
À¼Á´¶ºÂµÃ²Ä¼¸º¼³¿º
µŸ¼ÆµÃµ³´ºÇ¾½¿µ
This guide provides instructions for removing and replacing field-replaceable
components, assemblies, and subassemblies. Unless otherwise noted, each
procedure in this guide assumes the following:
±
The computer and any attached peripherals are turned off, and the
peripherals are disconnected from the I/O panel on the back of the
computer.
±
A part can be replaced by performing the removal procedure in reverse
order.
When the display assembly is open nearly 180 degrees, use a book or
something similar to support it. The angle of the display assembly with respect
to the bottom case should never be allowed to exceed 180 degrees. Also,
when performing the procedures in this guide, the locations or directions
relative to the computer are as shown in Figure 1 unless otherwise specified.
±²³´µ¶·¸¹··º»¼½´¾¶µ·¿µ²¶À¾Á¾²»À
right side
left side
back of computer
front of computer