Dell Latitude CP Replacement Instructions - Page 46

Bottom Case Bracket, Insert the end of a small flat-bladed screwdriver into the slot in

Get Dell Latitude CP PDF manuals and user guides View all Dell Latitude CP manuals
Add to My Manuals
Save this manual to your list of manuals

Page 46 highlights

left speaker wires plastic retaining clip 5-mm screws (4) left speaker slot right speaker 1. Remove the palmrest assembly. 2. Remove the audio board shield. 3. Disconnect the speaker wires from connectors JP1 and JP2 on the audio board. The connectors are fragile-do not pull on the speaker wires to disconnect them. 4. Remove the two 5-mm screws at each end of the bottom case bracket. 5. Insert the end of a small flat-bladed screwdriver into the slot in the vertical support in the center of the bottom case, and disengage the plastic retaining clip. 6. Lift the bottom case bracket from the computer. NOTE: When replacing the bottom case bracket, follow these guidelines to prevent damage to the speaker wires: Orient each speaker in the bottom case so that its wires are facing upwards. Route the speaker wires under their respective retaining clips on the bottom case bracket. 40 Dell Latitude CP and CPi - Parts Removal and Replacement Guide

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
40
Dell Latitude CP and CPi
—
Parts Removal and Replacement Guide
ÇÃÊÊþºÅ²¸¼ºÇ³²È¹¼Êº
±²³´µ¶·Â0¹··Ä»¾¾»¼·ºÁǶ·ÄµÁÎ/¶¾·Ê¶¼»ËÁÉ·
1.
Remove the palmrest assembly.
2.
Remove the audio board shield.
3.
Disconnect the speaker wires from connectors JP1 and JP2 on the
audio board.
The connectors are fragile
—
do not pull on the speaker wires to
disconnect them.
4.
Remove the two 5-mm screws at each end of the bottom case
bracket.
5.
Insert the end of a small flat-bladed screwdriver into the slot in the
vertical support in the center of the bottom case, and disengage the
plastic retaining clip.
6.
Lift the bottom case bracket from the computer.
NOTE: When replacing the bottom case bracket, follow these guidelines to
prevent damage to the speaker wires:
±
Orient each speaker in the bottom case so that its wires are facing
upwards.
±
Route the speaker wires under their respective retaining clips on the
bottom case bracket.
5-mm screws (4)
plastic retaining clip
left speaker
wires
right speaker
left speaker
slot