Dell PowerEdge 4300 Dell PowerEdge 4300 Systems Service Manual - Page 45

Installation, and Troubleshooting, Guide

Get Dell PowerEdge 4300 PDF manuals and user guides View all Dell PowerEdge 4300 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

Table 3-2 lists (in alphabetical order) system messages that can appear on the monitor screen. These messages can help you find the source of a problem. Some of these messages indicate fatal errors. When a fatal error occurs, the system cannot usually be rebooted until an appropriate hardware change has been made. Attempted to run system with more than six hard-disk drives and only one power supply Install a PSPB with additional power supplies. Faulty diskette/tape drive subsystem or hard-disk drive subsystem (defective system board) Combination of unbuffered and registered DIMMs installed Diskette drive or hard-disk drive controller cannot send data to associated drive Mouse cable connector loose or improperly connected; defective mouse Faulty diskette/tape drive subsystem or hard-disk drive subsystem (defective system board) Replace the system board. Replace one or more DIMMs so that all DIMMs are the same type. See "Installing DIMMs" and "Removing DIMMs" in Chapter 8 of the system's Installation and Troubleshooting Guide. Replace the drive's interface cable. Check the mouse cable connection. If the problem persists, replace the mouse. Replace the system board. Codes and Messages 3-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
Codes and Messages
3-5
6\VWHP±0HVVDJHV
Table 3-2 lists (in alphabetical order) system messages that can appear on the
monitor screen. These messages can help you find the source of a problem.
Some of these messages indicate fatal errors. When a fatal error occurs, the
system cannot usually be rebooted until an appropriate hardware change has
been made.
7DEOH±¶´µ³±6\VWHP±0HVVDJHV
0HVVDJH
&DXVH
&RUUHFWLYH²$FWLRQ
$±PD[LPXP±RI±
VL[±KDUG±
GULYHV±LV±
DOORZHG±ZLWK±
RQH±SRZHU±
VXSSO\
Attempted to run
system with more
than six hard-disk
drives and only one
power supply
Install a PSPB with addi-
tional power supplies.
$GGUHVV±PDUN±
QRW±IRXQG
Faulty diskette/tape
drive subsystem or
hard-disk drive sub-
system (defective
system board)
Replace the system
board.
$OHUW²±
8QEXIIHUHG±
DQG±UHJLV³
WHUHG±’,00V±
FDQQRW±EH±
PL[HG
Combination of un-
buffered and
registered DIMMs
installed
Replace one or more
DIMMs so that all
DIMMs are the same
type. See “Installing
DIMMs” and “Removing
DIMMs” in Chapter 8 of
the system’s
Installation
and Troubleshooting
Guide
.
$WWDFKPHQW±
IDLOHG±WR±
UHVSRQG
Diskette drive or
hard-disk drive con-
troller cannot send
data to associated
drive
Replace the drive’s inter-
face cable.
$X[LOLDU\±
GHYLFH±
IDLOXUH
Mouse cable con-
nector loose or
improperly
connected;
defective mouse
Check the mouse cable
connection. If the prob-
lem persists, replace the
mouse.
%DG±HUURU³
FRUUHFWLRQ±
FRGH´(&&µ±RQ±
GLVN±UHDG
&RQWUROOHU±
KDV±IDLOHG
Faulty diskette/tape
drive subsystem or
hard-disk drive sub-
system (defective
system board)
Replace the system
board.