Dell PowerEdge C4140 EMC Installation and Service Manual - Page 101
Removing a GPU riser cable board
![]() |
View all Dell PowerEdge C4140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Next steps Remove the GPU riser cable board. Removing a GPU riser cable board Prerequisites 1. Follow the safety guidelines listed in Safety instructions on page 57. 2. Follow the procedure listed in Before working inside your system on page 58. 3. Keep the Philips #2 screwdriver ready. 4. Disconnect the power cables connected to the GPU. 5. Remove the GPU from the chassis. Steps 1. Remove the screws securing the GPU riser cable board to the GPU. 2. Pull the GPU riser cable board to disengage the connector on the GPU riser cable board from the GPU. 3. Remove the GPU riser cable routed through the GPU riser cable clip. Figure 69. Removing a GPU riser cable board NOTE: The procedure to remove the riser cable clip is same for configuration B, C and G. PowerEdge C4140 installing and removing system components 101
![](/manual_guide/products/dell-poweredge-c4140-emc-installation-service-manual-9ffb8d4/101.png)