Dell PowerEdge C4140 EMC Installation and Service Manual - Page 69
Removing the 2.5-inch drive cage cover
![]() |
View all Dell PowerEdge C4140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Figure 35. Installing the 2.5-inch drive cage Next steps 1. Connect the power cable to the system board. 2. Connect the signal cables to the system board or expansion card. 3. Follow the procedure listed in After working inside your system. Removing the 2.5-inch drive cage cover Prerequisites 1. Follow the safety guidelines listed in the Safety instructions section. 2. Follow the procedure listed in Before working inside your system. 3. Remove the 2.5-inch drive cage. 4. Keep the Phillips #1 screwdriver ready. Steps 1. Remove the screws securing the drive cage cover to the drive cage. 2. Slide the drive cage cover toward the front of the drive cage to disengage it from the slots on the drive cage. 3. Lift the drive cage cover away from the drive cage. PowerEdge C4140 installing and removing system components 69
![](/manual_guide/products/dell-poweredge-c4140-emc-installation-service-manual-9ffb8d4/69.png)