Dell PowerEdge C4140 EMC Installation and Service Manual - Page 61
Installing the rear system cover
![]() |
View all Dell PowerEdge C4140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Figure 26. Removing the rear system cover Installing the rear system cover Prerequisites 1. Follow the safety guidelines listed in the Safety instructions section. 2. Power off the system and all attached peripherals. 3. Disconnect the system from the electrical outlet and disconnect the peripherals. 4. If applicable, remove the system from the rack. NOTE: For more information, see the Rail Installation Guide at www.dell.com/poweredgemanuals. 5. Ensure that all internal cables are routed correctly and connected, and no tools or extra parts are left inside the system. Steps 1. Align the tabs on the system cover with the guide slots on the system and slide the cover towards the front of the system. The system cover slides forward, the tabs on the system cover engage with the guide slots on the system and the system cover latch locks into place. 2. Using a Phillips #2 screwdriver, secure the cover in place with screws. PowerEdge C4140 installing and removing system components 61
![](/manual_guide/products/dell-poweredge-c4140-emc-installation-service-manual-9ffb8d4/61.png)