Dell PowerEdge R750 EMC Installation and Service Manual - Page 143
Installing the expansion card risers, Installing the Riser 4 blank
![]() |
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Figure 132. Installing the Riser 4 blank Next steps 1. Replace the expansion card riser. Installing the expansion card risers Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in Before working inside your system. 3. If removed, install the expansion cards into the expansion card risers. NOTE: Install Riser 2 before installing Riser 1 and Riser 3. Install Riser 4 after installing Riser 3. CAUTION: Do not install GPUs, network cards, or other PCIe devices on your system that are not validated and tested by Dell. Damage caused by unauthorized and invalidated hardware installation will null and void the system warranty. Steps 1. If installed, remove the riser blanks and if required loosen the captive screws. NOTE: Store the riser blanks for future use. Filler brackets must be installed in empty expansion card slots to maintain Federal Communications Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system Installing and removing system components 143
![](/manual_guide/products/dell-poweredge-r750-emc-installation-service-manual-5386569/143.png)