Dell PowerEdge R750 EMC Installation and Service Manual - Page 67
Installing the drive backplane
![]() |
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 67 highlights
Figure 63. Removing the drive backplane Next steps 1. Replace the drive backplane. Installing the drive backplane Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the backplane cover. 4. If installed, remove the air shroud or remove the GPU air shroud. 5. Remove all the drives. 6. Remove the cooling fan cage assembly. NOTE: To avoid damaging the backplane, ensure to move the control panel cables from the cable routing clips before removing the backplane. NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped. Steps 1. Align the slots on the drive backplane with the guides on the system. 2. Slide the drive backplane into the guides and lower the backplane until the blue release tabs clicks into place. 3. Route the cables properly through the cable guide. Installing and removing system components 67
![](/manual_guide/products/dell-poweredge-r750-emc-installation-service-manual-5386569/67.png)