Dell PowerEdge R750 EMC Installation and Service Manual - Page 148
Removing expansion card from the expansion card riser
![]() |
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
Removing expansion card from the expansion card riser Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. If applicable, disconnect the cables from the expansion card. 4. Remove the expansion card riser. Steps 1. Pull and rotate the expansion card retention latch lock to open. 2. Pull the card holder before removing the card from the riser. 3. Hold the expansion card by the edges. and pull the card from the riser. NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence. Figure 141. Removing expansion card from the expansion card riser 4. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch. 148 Installing and removing system components
![](/manual_guide/products/dell-poweredge-r750-emc-installation-service-manual-5386569/148.png)