Dell PowerEdge R750 EMC Installation and Service Manual - Page 212
Table 70. GPU power cable matrix continued, Category, Description, Vendor, Cable, Cable quantity
![]() |
View all Dell PowerEdge R750 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 212 highlights
Table 70. GPU power cable matrix (continued) Category Description Type Vendor HH - Half Height, HL - Half Length, FH - Full Height, FL - Full Length Cable Cable quantity NOTE: Maximum of two double width GPUs with power cables or a maximum of eight single widh GPUs are supported in a system. 8. Install the full length expansion card riser or half height expansion card riser. See GPU kit components table for supported GPU risers. 9. Install the GPU air shroud filler. 10. Install the GPU air shroud top cover. 11. Install the foam on the system cover. To install the foam, a. Place the system cover with the System Information Lable (SIL) side facing up. b. For easier handling, peel off a small section of the adhesive cover and align the foam with the system cover. c. Remove rest of the adhesive cover, and install foam on the system cover. d. Press along the length of the foam to ensure that it is firmly affixed to the system cover. Figure 216. Installing Mylar foam on the system cover After installing, follow the After working inside the system instructions. 212 Upgrade Kits
![](/manual_guide/products/dell-poweredge-r750-emc-installation-service-manual-5386569/212.png)